Use Your Freezer for Your Bearings

March 08, 2011
Quick Tips
A Waterloo, IA viewer writes: Put your bearing races in the freezer for about 20 minutes before pressing them in. The freezer temperature makes them contract so they go in easier. Stacey adds: Good Tip! This is also true of urethane and rubber bushings as well as press-in studs.

Recent News

  • The old Weasel resurfaces for a minute. Going to try and get it back to the garage for season 14 of GearZ!!!

  • Stacey and Copperhead are back together after 12 long years. Always good to see this truck, even if it's just for a quick stomp on the gas pedal!

  • Stacey shows how modifying a TMI Products Mustang trunk kit helped him get the

  • Von Hotrod and Stacey getting ready for a shot. We get some of the best conversations before we call "Action!"

  • Skyjacker Suspensions is giving away any 2"-4" DUAL RATE LONG TRAVEL KIT for a JT/JL/JK/TJ/XJ

  • We are lucky to have a lot of original vehicles pass through the garage.